John Wallis Titt must have passed this way many a time in his youth to tend the post mill at the end of Tyning Path. That early experience probably led to his interest in windmills and later engineering achievements in raising water by wind power.
Elm Farm Road and Tyning Path are two parts of the same track. Tyning Path is numbered 9 on the Rights of Way map. They meet at the crossing with Farm Hill/Long Hill. They are both also part of the Imber Range Perimeter Path, IRPP, a favourite of walkers, runners and riders.
Elm Farm Road leads off Back Lane and is still designated a road on most maps. So called because it once was the road from the farmyard to the fields and mill attached to Elm Farm. Elm Farm is no more but the road’s old stone paving can still be seen, when not obliterated by enormous badger workings. It heads gradually uphill until it meets Farm Hill/Long Hill near the radio mast and barn. Here it becomes Tyning Path.
Tyning Path is not paved, but carries on gently rising to the highest point where the post mill once stood in a good position to catch the wind in its sails. Now there is nothing left of the mill but according to the old maps it stood to the right of Tyning Path at a crossing with an unnamed track that heads towards the Pumping Station. But back in John Wallis Titt’s time, say about 1850, the mill still existed and may have been working at grinding the corn into flour.
I don’t think there are any post mills left in Wiltshire now, but this photograph shows the construction quite well. The point being that the whole structure above the base could revolve around the central post to take advantage of the prevailing wind.
A tyning was a small area of enclosed ground. We would call it an allotment today.